Silicon Image SataRaid Manual de usuario descargar pdf (Pagina 11)

5. When prompted, press S to specify the location of the driver.

6. Insert the floppy disk, then press Enter.

7. Select Silicon Image SiI 3x12 SATARAID Controller for

Windows NT 4.0 and 2000, then press Enter.

8. Press Enter again to finish driver installation, then follow the

on-screen instructions to complete the Windows installation.

For An Existing Installation

1. Setup the RAID Array prior to driver installation and boot up to

Windows.

2. At Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device(recommend)

then click Next.

4. Insert the driver CD, check CD-ROM drives, uncheck the other

boxes, click Next, then click Next again.

5. If the Digital Signature Not Found message appears, click Yes .

Our driver has been thoroughly tested for stability and

compatibility.

6. Click Finish.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Silicon Image SataRaid Manual de usuario Pagina 11